Keeping two wires aligned can be the awkward part of soldering. This dual-clamp holder handles that positioning task; here is what it offers and what to check for your projects.

When both hands are occupied with a soldering iron and solder, keeping two wires in position can be awkward. The Soldering Wire Holder with Dual Clamps addresses that specific task by gripping two wires for hands-free holding.
Its paired tooth-style clamps and angled jaws help keep the wires aligned, while a wide base supports the holder on your work surface. For shoppers, the main question is whether this focused holding tool suits the wires and workspace they use.
A holder focused on two wires
This model has capacity for two wires. Its purpose is to maintain their position while you solder, rather than provide a complete soldering setup.
When comparing a soldering wire clamp with other holding tools, start with what needs support. If your task involves two wires, this holder is designed around that need. If you need to support a circuit board or a larger assembly, assess those requirements separately rather than assuming a wire clamp will accommodate them.
Match the holder to your working space
The holder is intended for electronics work, hobby projects, automotive wiring, and DIY repairs. Its compact, lightweight design is suited to bench setups, field repairs, and toolboxes.
As general buying advice, consider the actual holding task rather than the project category alone. A hobby project and an automotive repair may both involve two wires, but wire size and access to the joint can differ.
- Check suitability for the wire sizes you use most often.
- Consider the space available around the joint for your tools.
- Confirm the holder's dimensions if storage or working space is tight.
What to confirm before choosing
An exact supported wire-gauge range is not specified for this model. The tooth-style clamps are described as accommodating various gauges, but that is not a guarantee of fit for every wire size. Confirm suitability if you have a particular gauge in mind.
Exact dimensions are also not supplied. If the holder needs to fit a particular toolbox compartment or a restricted work area, request measurements before making that decision.
Material, options, and design credit
This 3D printed wire holder for soldering is made from PETG. It is available in Gray, Red, or White, and each purchase includes one soldering wire holding station in your chosen color.
The holder is based on the design published on Thingiverse as Thing 7033070. Full design credit goes to the original designer.
If holding two wires aligned is the extra help your soldering work needs, consider the Soldering Wire Holder with Dual Clamps from 3D Craft Supply. Confirm fit for your wire size and workspace, then choose your preferred available color.
Soldering Wire Holder with Dual Clamps
