Find a practical location for your FT-857 control head. This holder supports flat-surface mounting in a vehicle, shack or workstation, with screws and adhesive supplied separately.

A useful control-head location needs more than an empty patch of wall or dashboard: you also need to see the display, reach the controls and leave room for connections. The Yaesu FT-857 head unit holder provides a flat-surface mounting option for the FT-857 control head in a vehicle, radio shack or workstation.
This 3D-printed PETG accessory supports wall, under-dash and under-desk installations. Choosing between those locations starts with your operating position and the surface available, rather than the holder alone.
Match the holder to your control head
The specified compatible model is the Yaesu FT-857. Choose this FT-857 control head mount for that model; compatibility with other radios is not established.
The item is a holder for the control head, and the radio is not included. When planning your layout, assess the space occupied by the control head and its connections, not just the mounting surface.
- Confirm that your control head is for the FT-857.
- Check display visibility and access to controls from your usual operating position.
- Allow space for cable connections without forcing tight bends.
Compare the available mounting locations
A Yaesu FT-857 wall mount arrangement is one option for a shack or workstation. Under-desk mounting is another supported arrangement worth considering when the wall is inconvenient or the area around the desk is already occupied.
Under-dash mounting is also a stated use for vehicle installations. As general placement advice, keep equipment clear of driving controls, airbag deployment areas and the driver's view. Check the intended location before selecting hardware or making changes to the vehicle.
For any location, consider whether the control head will remain comfortable to view and operate. A convenient attachment point is not necessarily a convenient operating position.
Consider flat and angled arrangements
The holder is made from lightweight, 3D-printed PETG plastic. The product photo shows a black, elongated holder with rectangular cutouts and round holes, alongside separate angled pieces.
Optional angled mounting pieces are available for custom installations and are described as pieces that can be glued on. If your layout depends on an angle, confirm which pieces are supplied and whether their arrangement suits your intended position before ordering.
Plan for mounting hardware separately
This radio control head holder attaches using standard screws. Screws and adhesive are not included, so plan for those supplies separately from the holder.
As general hardware-selection advice, choose fasteners appropriate to the mounting surface and confirm the required screw dimensions before buying them. If you intend to use the optional angled pieces, also confirm suitable adhesive guidance rather than assuming any adhesive will work.
For an FT-857 control head that needs a dedicated mounting location, consider this holder from 3D Craft Supply. Check your available surface, viewing position and hardware needs, then confirm any optional angled pieces required for your setup.
Head Unit Holder for Yaesu FT-857
